Gotta part ways with my hot rod, poor health forces the issue. 350 LT1 injected engine goes with it including the complete engine harness and ECM, 4L60 trans with major valve body mods and reprograming, electric fuel pump with filter, air shocks, fuel cell, stainless braided fuel line with pressure regulator, moser rear axles, Auburn cone type posi unit (no clutch packs to worry about), 4.56 gear set, heavy duty aluminum diff cover with girdle bolts for extra strength, heavy duty front and rear UMI sway bars, QA1 anti hop bars, drive shaft safety loop if you run slicks, line loc, B&M ratcheting shifter with line loc button in the handle aluminum dash with gages, tilt column, original stainless body trim comes with it, UMI rear lower control arms. Polyurethane body bushings. No rust anywhere except for minor surface rust on the primer. Front and rear fiberglass bumpers, lift off fiberglass hood. Been sitting about 7 years so it will need to be towed. Make me a reasonable offer, I might take it. The car is locate in Longview, Washington.